Chastity Cage Assembly Guide

Step 1 – Sizing The Ring:

Find the chastity ring size that fits a little loose around your scrotum. You should have enough room to fit the tip of your pinky finger between the ring and skin. Once closed, find the longest locking pin (D) and slide it through.

The ring should now sit comfortably on your body, and not slide off. If you feel it is tight, or you notice any discoloration (blueish/purplish color or pale white and cold) with your shaft or testicles, then the ring is too tight and needs to be moved up one size and tried again.

 Step 2 – Lubricate The Cock Cage

Start with the longest spacer (D), and fasten the side with 4 prongs into the cage – it should “snap” into place.

Next, get some lubrication or lotion (we recommend unscented moisturizing lotion), and rub a small amount of it around the inside of the cage, covering as much of the inside surface as possible (you don’t need a lot here, it just needs to be spread out). Now comes installing the cage.

 Step 3 – Fighting Off The Erection

If you’re like most, on your first lockup you may be sporting a fantastic erection at this point. We’re going to need to calm that down. Try to distract yourself with a chore or something mentally tedious (like math), until you feel yourself getting soft, very soft, and very calm. Until you even forget you’re wearing the ring (you’re still wearing it right?!).

If you are impatient, you can also ice your erection down until it is soft.

Step 4 – Chastity Cage Assembly

Now it’s time to be quick. Take a little bit of lubrication/lotion, and coat your flaccid penis (again, only a little amount is needed). Then stick the head of your penis into the cock cage, and slide it over your shaft until the back-end of the spacer is close to the locking pin sticking out of the ring.

Align the chastity cage so the locking pin slides through the hole and continue to sliding it on until it meets with the ring.

Pro Tip

You may want to stick a finger underneath the top of the ring to tuck your skin away from the parts coming together here. Once the cage meets the ring, hold the pieces together until Step 6.

If you happen to get an erection during assembly, don’t force it on. Go back to Step 3 and try again.

Step 5 – Inserting The Locking Cap

Take the locking cap (no anti-pullout option), and slide it over the cage and locking pin. Then squeeze all of the parts together while you slide the padlock through the hole and lock it shut.

It’s best to not use the anti-pullouts in the beginning, and instead, use the locking cap during your first few assemblies. This will help you identify your ideal ring and spacer sizes much easier than adding the complexity of an additional component.

Step 5.1 – Locking The Anti Pullouts

When you are ready for the Anti-Pullouts, START WITH THE LARGEST anti-pullout first. Align the hinge to the tongue groove at the bottom of the cage. Slowly clamp the anti-pullout in place until it is fully closed around the locking pin. Slide the padlock through and lock it shut.

When sizing the anti-pullout, be sure to start with the largest and wait 2 days for the skin to mold to the texture to get the maximum security effect. If you find the anti-pullout is still not secure at that time, then downsize to the next smallest size. In the beginning, be sure to remove the device every 3-5 days to check on the skin to ensure there are no adverse reactions to the anti-pullout.

Chastity Assembly Complete. You’re Locked Up!

Congratulations! You are now locked up. If the fit doesn’t feel just right yet, please head over to our chastity cage sizing guide to see the chastity sizing troubleshooting for additional tips and insight. And, here’s a video of all the steps listed above, for your convenience.